​tig welding torch setting tungsten stick out length for fillet welds
Share this video:
https://www.youtube.com/watch?v=6x4CjwSPvMg
​
Get more tips – subscribe →

https://www.youtube.com/channel/UCYcAVANw1ybwe18GSirsHlw

In this video titled “tig welding torch setting tungsten stick out length for fillet welds” Stuart Graves explains the correct method to set the tungsten stick out length when performing a fillet weld. This technique is required when wilding with the Gas Tungsten Arc Welding (GTAW) process which is also known as the Tungsten Inert Gas (TIG) welding process.
The initial set up of “tig welding torch setting tungsten stick out length for fillet welds” looks at the following aspects:

Loosen back cap 0:16
Ceramic touching plate 0:27
Tighten back cap 0:28
Retract Tungsten 2mm 0:48

Make sure you click the subscribe button to receive alerts of new posts.

Tig weld torch, Setting tungsten stick out length, Fillet welds, GTAW, TIG, Tig welding beginners, Beginners welding, Tig beginners, Tig settings, Tig start up, Tig torch set up, Operator techniques, Tig welding process
Tungsten stick out length, Tungsten preparation, Tighten back cap, Angle of approach, Travel angle, DC negative, Thoriated tungsten, Zirconiated Tungsten, Gtaw initial set up, Midland metal fab, Midland metal fabrication, Perth welding training.

Instagram
the boiler shop.com.au